Hivatkozási szám

MSZ EN ISO 17662:2026

Dokumentumazonosító

187241

Cím

Hegesztés. A hegesztésre és a hozzá tartozó tevékenységekre használt berendezések kalibrálása, igazoló és érvényesítő ellenőrzése (ISO 17662:2025)

Angol cím

Welding. Calibration, verification and validation of equipment used for welding, including ancillary activities (ISO 17662:2025)

Alkalmazási terület

This document specifies requirements for calibration, verification and validation of equipment used for: — control of process variables during fabrication, — control of the properties of equipment used for welding or welding allied processes, where the resulting output cannot be readily or economically documented by subsequent monitoring, inspection and testing. This involves process variables influencing the fitness-for-purpose and in particular the safety of the fabricated product. NOTE This document is based on the lists of process variables stated in International Standards for specification of welding procedures, in particular, but not exclusively in the ISO 15609 series. Future revisions of these International Standards can result in addition or deletion of parameters considered necessary to specify. Some guidance is, in addition, given in Annex B for requirements for calibration, verification and validation as part of acceptance testing of equipment used for welding or allied processes. This document does not specify requirements to calibrate, verify and validate as part of inspection, testing, non-destructive testing or measuring of final welded products performed in order to verify product conformance. This document applies only to calibration, verification and validation of equipment for use in production or on site. This document does not apply to the manufacture and installation of equipment for welding. Requirements for new equipment are formulated in directives and product codes (standards), as necessary. Annex C provides information when other parties are involved in calibration, verification and validation activities.

ICS

25.160.30 Hegesztőberendezések

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2026-02-01

Forrás

idt EN ISO 17662:2025; idt ISO 17662:2025

Előd

MSZ EN ISO 17662:2016

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 1256837) ,

oldalszáma

36 oldal; R kategória

ára

Nettó: 18760 Ft
Bruttó:
Papír formátum esetén (25% nyomdai költséggel, 5% Áfával): 24623 Ft
PDF (letöltés) formátum esetén ( 27% Áfával): 23825 Ft