Hivatkozási szám

MSZ IEC/TS 62578:2024

Dokumentumazonosító

184758

Cím

Teljesítményelektronikai rendszerek és berendezések. Az aktív betáplálású átalakítók (AIC) működési feltételei és jellemzői, beleértve a 150 kHz alatti kibocsátási értékekre vonatkozó tervezési ajánlásokat is

Angol cím

Power electronics systems and equipment. Operation conditions and characteristics of active infeed converter (AIC) applications including design recommendations for their emission values below 150 kHz

Alkalmazási terület

This Technical Specification IEC TS 62578 describes the operation conditions and typical characteristics of active infeed converters (AIC) of all technologies and topologies which can be connected between the electrical power supply network (lines) a.c. side and a constant current or voltage type d.c. side and which can convert electrical power (active and reactive) in both directions (generative or regenerative). Applications with active infeed converters are commonly used with the d.c. sides of adjustable speed power drive systems (PDS), uninterruptible power systems (UPS), active filters, photovoltaic systems, wind turbine systems, battery backed power management systems etc. of all voltages and power ratings. Active infeed converters are generally connected between the electrical power supply network (a.c. side) and a current or voltage d.c. side, with the objective to avoid emitting low frequency harmonics (e.g. less than 1 kHz) by synthesizing a sinusoidal a.c. current. Some of them can additionally compensate the pre-existing harmonic distortion of a given supply side voltage. They are moreover able to control the power factor of a power supply network section by moving the electrical power (active and reactive) in both directions (generative or regenerative), which enables energy saving in the system and stabilizes the power supply voltage or enables coupling of renewable energy sources or electrical energy storage devices to the supply. A practical and analytical approach for emission values for AICs in power supply networks is given, which is based on the latest results for line impedance values between 2 kHz and 9 kHz and withstand capability of capacitors connected directly to the supply. This results in design recommendations for emission values below 150 kHz. The following is excluded from the scope. - Requirements for the design, development or further functionality of active infeed applications. - Probability of interactions or influences of the AIC with other equipment caused by parasitic elements in an installation or caused by poor electronic design as well as their mitigations. - "Overhead line" power supply networks because of lack of information (measurements) of their three phase impedances. This could be the subject for future editions.

ICS

29.200 Egyenirányítók. Áramátalakítók. Stabilizált tápegységek

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2024-12-01

Forrás

idt IEC/TS 62578:2015

Előd

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 7289335) ,

oldalszáma

110 oldal; XC kategória

ára

Nettó: 28640 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 36086 Ft
PDF (letöltés) formátum esetén (27% Áfával): 36373 Ft