Hivatkozási szám

MSZ EN 303 213-6-1:2016

Dokumentumazonosító

163801

Cím

Fejlett, földi mozgást irányító és ellenőrző rendszer (A-SMGCS). 6. rész: A telepített gurítóradar-érzékelőkre vonatkozó, a 2014/53/EU irányelv 3. cikke (2) bekezdésének alapvető követelményeit tartalmazó, harmonizált szabvány. 1. alrész: Impulzusjeleket használó és legfeljebb 100 kW teljesítményt sugárzó X-sávú érzékelők

Angol cím

Advanced Surface Movement Guidance and Control System (A-SMGCS). Part 6: Harmonised Standard covering the essential requirements of article 3.2 of the Directive 2014/53/EU for deployed surface movement radar sensors. Sub-part 1: X-band sensors using pulsed signals and transmitting power up to 100 kW

Alkalmazási terület

The present document applies to X-band radar sensors intended for the surveillance of airport surface movement traffic with the following characteristics: • Operating in one or both of the following frequency ranges: - 9 000 MHz to 9 200 MHz and 9 300 MHz to 9 500 MHz utilizing modulated or unmodulated pulses. • Transmitter Peak Envelope Power up to 100 kW. • The transceiver-antenna connection is using a hollow metallic rectangular waveguide. • The antenna is rotating, waveguide-based and passive. • At the transceiver output an RF-circulator is used. NOTE 1: Since transceiver and antenna are hollow metallic rectangular waveguide based the frequency range for measurements that needs to be addressed covers 6,56 GHz to 26 GHz. The lower limit of this frequency range is obtained as cut-off frequency of the combination of WR112/R84 taper section and a WR90/R100 Waveguide IEC 60153-2 [i.3]. The upper limit corresponds to the upper limit stated in ERC/Recommendation 74-01 [i.5]. NOTE 2: Since at the transceiver output an RF circulator is used, it is assumed that the transceiver characteristics remain independent from the antenna. NOTE 3: Aeronautical Surface Movement Radars covered by the present document are expected to use the bands 9 000 MHz to 9 200 MHz and/or 9 300 MHz to 9 500 MHz. According article 5 of the ITU Radio Regulations [i.6] the band 9 000 MHz to 9 200 MHz is allocated to the Aeronautical Radionavigation Service on a primary basis and the band 9 300 MHz to 9 500 MHz is allocated to the Radionavigation Service on a primary basis. The present document contains requirements to demonstrate that "... Radio equipment shall be so constructed that it both effectively uses and supports the efficient use of radio spectrum in order to avoid harmful interference" [i.1]. In addition to the present document, other ENs that specify technical requirements in respect of essential requirements under other parts of article 3 of the Radio Equipment Directive 2014/53/EU [i.1] as well as essential requirements under the SES Interoperability Regulation 552/2004 [i.9] and related implementing rules and/or essential requirements under the EASA basic regulation 216/2008 [i.12] may apply to equipment within the scope of the present document.

ICS

49.090 Fedélzeti berendezések és műszerek

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2016-10-01

A visszavonás napja

2021-03-31

Forrás

idt EN 303 213-6-1:2016-05

Előd

MSZ EN 303 213-6-1:2014

Utód

MSZ EN 303 213-6-1:2019

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

2014/53/EU (RTTE14); 1999/5/EK; (RTTE99)

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 279682) ,

oldalszáma

26 oldal; P kategória

ára

Nettó: 12520 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 15775 Ft
PDF (letöltés) formátum esetén (27% Áfával): 15900 Ft