Hivatkozási szám

MSZ EN 302 842-4:2015

Dokumentumazonosító

161590

Cím

VHF-sávú, levegő-föld és levegő-levegő közötti digitális kapcsolatú (VDL), 4-es üzemmódú rádióberendezés. A légi mozgó (légijármű-fedélzeti) berendezések műszaki jellemzői és mérési módszerei. 4. rész: Pont-pont közötti funkciók

Angol cím

VHF air-ground and air-air Digital Link (VDL) Mode 4 radio equipment. Technical characteristics and methods of measurement for aeronautical mobile (airborne) equipment. Part 4: Point-to-point functions

Alkalmazási terület

The present document applies to the following radio equipment types: • Very High Frequency (VHF) Digital Link (VDL) Mode 4 aeronautical mobile (airborne) radio transmitters, transceivers and receivers for air-ground and air-air communications operating in the VHF band, using Gaussian Filtered Frequency Shift Keying (GFSK) modulation with 25 kHz channel spacing and capable of tuning to any of the 25 kHz channels from 112,000 MHz to 136,975 MHz as defined in ICAO VDL SARPs [2]. The present document provides part 4 of the technical specifications. The present document is designed to ensure that equipment certified to it will be compatible with the relevant ICAO VDL SARPs [2] and ICAO VDL4 Technical Manual [1]. Manufacturers should note that in future the tuning range for the transmitter and receiver may also cover any 25 kHz channel from 108,000 MHz to 111,975 MHz. The present document applies to "aeronautical mobile (airborne and as applicable also ground vehicles)" equipment which will hereinafter be referred to as "mobile" equipment. The scope of the present document is limited to mobile stations. The equivalent specification for ground stations is ETSI EN 301 842 [i.1]. A description of the scope of the VDL Mode 4 system is provided in part 2 of ETSI EN 302 842-2 [6], clause 1. ETSI EN 302 842-1 [5] deals with tests of the physical layer, ETSI EN 302 842-2 [6] deals with core link layer functionality and ETSI EN 302 842-3 [7] with additional broadcast functionality. The present document deals with tests of the datalink layer (DLS) and the link layer sufficient to support point-to-point functionality. Note that, as described in ETSI EN 302 842-2 [6], a system supporting point-to-point functionality is required to conform to ETSI EN 302 842-1 [5], ETSI EN 302 842-2 [6] and the specification in the present document. The present document is organized as follows: • clause 2 provides references to relevant documents; • clause 3 provides general definitions, abbreviations and symbols used; • clause 4 describes the VDL Mode 4 mobile station point-to-point functions; • clause 5 provides performance specifications for the VDL Mode 4 mobile station; • clause 6 provides general design requirements; • clause 7 provides protocol tests for the point-to-point functions of the system; • annex A provides a detailed cross-reference to the relevant requirements contained in ICAO VDL4 Technical Manual [1]. Note that the system can support a very wide range of functions. It is not practical to provide specific tests for all aspects of functionality. The approach used is to provide detailed tests for the core point-to-point functionality and to provide tests of those remaining requirements which, if wrongly implemented, could cause a deterioration in the service offered by other VDL Mode 4 stations. Mandating and Recommendation Phrases a) "Shall": - The use of the word "Shall" indicates a mandated criterion; i.e. compliance with the particular procedure or specification is mandatory and no alternative may be applied. b) "Should": - The use of the word "Should" (and phrases such as "It is recommended that...", etc.) indicates that though the procedure or criterion is regarded as the preferred option, alternative procedures, specifications or criteria may be applied, provided that the manufacturer, installer or tester can provide information or data to adequately support and justify the alternative.

ICS

33.040.20 Átviteli rendszerek

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2015-10-01

Forrás

idt EN 302 842-4:2015-04

Előd

MSZ EN 302 842-4:2011

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 1202756) ,

oldalszáma

187 oldal; XD kategória

ára

Nettó: 33350 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 42021 Ft
PDF (letöltés) formátum esetén (27% Áfával): 42355 Ft