Hivatkozási szám

MSZ EN 1714:2001

Dokumentumazonosító

112629

Cím

Hegesztett kötések roncsolásmentes vizsgálata. Hegesztett varratok ultrahangos vizsgálata

Angol cím

Non destructive examination of welds. Ultrasonic examination of welded joints

Alkalmazási terület

This European Standard specifies methods for the manual ultrasonic examination of fusion welded joints in metallic materials equal to and above 8 mm thick which exhibit low ultrasonic attenuation (especially that due to scatter). It is primarily intended for use on full penetration welded joints where both the welded and parent material are ferritic. Where specified and appropriate, techniques may also be used : - on materials other than those stated ; - on partial penetration welds ; - with automated equipment by agreement between the contracting parties. Where material dependent ultrasonic values are specified in this standard they are based on steels having an ultrasonic sound velocity of 5920 n 50 m/s for longitudinal waves, and 3255 n 30 m/s for transverse waves. This is to be taken into account when examining materials with a different velocity. The standard specifies four examination levels, each corresponding to a different probability of detection of imperfections. Guidance on the selection of examination levels A, B and C is given in annex A. The requirements of the fourth examination level, which is intended for special applications, are in accordance with the general requirements of this standard and as agreed between the contracting parties. This standard, by agreement between the contracting parties, permits assessment of indications, for acceptance purposes, by either of the following methods : 1) Evaluation based primarily on length and echo amplitude of the signal indication ; 2) Evaluation based on characterization and sizing of the indication by probe movement methods.

ICS

25.160.40 Hegesztett kötések és hegesztések

Műszaki Bizottság

A szabvány nyelve

magyar

Az érvényesség kezdete

2001-03-01

A visszavonás napja

2004-06-01

Forrás

idt EN 1714:1997

Előd

Utód

MSZ EN 1714:2004

Módosítás

MSZ EN 1714:1997/A1:2002

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

(SPV01)

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 306248) ,

oldalszáma

32 oldal; P kategória

ára

Nettó: 12520 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 15775 Ft
PDF (letöltés) formátum esetén (27% Áfával): 15900 Ft