Hivatkozási szám

MSZ EN ISO 14126:2024

Dokumentumazonosító

183427

Cím

Szálerősítésű műanyag kompozitok. A nyomási jellemzők meghatározása kétdimenziós irányban (ISO 14126:2023)

Angol cím

Fibre-reinforced plastic composites. Determination of compressive properties in the in-plane direction (ISO 14126:2023)

Alkalmazási terület

1.1 This document specifies methods for determining the compressive properties, in directions parallel to the plane of lamination, of fibre-reinforced plastic composites, based on thermosetting or thermoplastic matrices. The compressive properties are of interest for specifications and quality-control purposes. The test specimens are machined from a flat test plate, or from suitable finished or semi-finished products. 1.2 Two loading methods and two types of specimen are described. The loading methods are: - Method 1: provides shear loading of the specimen (gauge length unsupported) - Method 2: provides combined loading of the specimen (gauge length unsupported) NOTE For tabbed specimens loaded using method 2, load is transferred through a combination of end-loading and shear-loading through the tabs. The specimen designs are: - Type A specimen: rectangular cross-section, fixed thickness, end-tabbed (mainly for aerospace style preimpregnates (~ 0,125 mm ply thickness) - Type B specimen: rectangular cross-section, range of thicknesses, untabbed or end-tabbed, two specimen sizes are available (B1 and B2). The Type A specimen is used for unidirectionally or biaxially reinforced materials tested in the fibre direction, where the fibres are normally either aligned continuous or aligned long (>7,5 mm) discontinuous. The Type B1 and B2 specimens are used for multi-directional aligned; mat, fabric and other multi-directionally reinforced materials where the fibre structure is more complex and/or coarser. 1.3 This document gives criteria for checking that the combination of test method and specimen design result in valid failures. It is noted that alternative test method/specimen combinations will not necessarily give the same result. 1.4 The methods specify required dimensions for the specimen. Tests carried out on specimens of other dimensions, or on specimens that are prepared under different conditions, can produce results that are not comparable. Other factors, such as the speed of testing, the support fixture used and the conditioning of the specimens, can influence the results.

ICS

83.120 Erősített műanyagok

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2024-04-01

Forrás

idt EN ISO 14126:2023; idt ISO 14126:2023

Előd

MSZ EN ISO 14126:2000

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 2891146) ,

oldalszáma

40 oldal; T kategória

ára

Nettó: 15850 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 19971 Ft
PDF (letöltés) formátum esetén (27% Áfával): 20130 Ft