Hivatkozási szám

MSZ EN 50341-2-7:2024

Dokumentumazonosító

183131

Cím

1 kV-nál nagyobb váltakozó feszültségű szabadvezetékek. 2-7. rész: Finnország nemzeti előírásai (NNA) (az EN 50341-1:2012 alapján)

Angol cím

Overhead electrical lines exceeding AC 1 kV. Part 2-7: National Normative Aspects (NNA) for FINLAND (based on EN 50341-1:2012)

Alkalmazási terület

1.1 General (ncpt) FI.1 Application of the standard in Finland In Finland, the standard EN 50341-1 (Part 1) can only be applied using this NNA (EN 50341-2-7) containing National Normative Aspects for Finland. The requirements of the standard are applied also for low voltage (below 1 kV AC) overhead lines. The requirements of the structural design are applicable also for DC overhead lines, where the electrical requirements are given in the Project Specification. This standard is applicable for new overhead lines only. (ncpt) FI.2 Application for existing overhead lines Overhead lines complying with the mechanical and electrical requirements of its original date of construction can be operated and maintained, if they do not cause obvious danger. The reparation and overhaul of lines can be done according to the previous requirements. Reparation means that a component which has been damaged is substituted with a similar new one. Overhaul means a wider improvement of the line for extending its lifetime. The basic structure remains same as before. This standard should be used for all modification works on existing lines. In the modification works, earlier norms and standards may also be used, if allowed by the valid Electrical Safety Act. In that case it shall especially be verified that changes in actions do not cause significant increase in the loads of the line. Modification work means e.g. relocation of some supports or an extension to a line by addition of a circuit or changing of the conductors to existing supports. 1.2 Field of application (ncpt) FI.1 Application to covered conductors and aerial cables The standard includes requirements for the design and construction of overhead lines equipped with covered conductors and aerial cables. Additionally, the requirements of the equipment standards and manufacturers’ instructions shall be considered. (ncpt) FI.2 Installation of other equipment Only equipment belonging to the line (electric or telecommunication line) can be installed on the overhead line supports. However, equipment serving communal services or environmental protection like telecommunication equipment, road signs, warning signs or warning balls may also be installed with the permission of the owner of the line. With the permission of the owner of the line, also other equipment than those mentioned above, can be installed on supports of the line equipped with aerial cables. If other equipment is installed on the supports, the requirements of safe working practices shall be considered. The installation height of equipment meant to be installed and maintained by an ordinary person shall be such that the work can be done without climbing the support and the distances of safe electrical work can be followed (see standard SFS 6002). The additional loads due to other equipment to the line shall be considered.

ICS

29.240.20 Energiaátviteli és -elosztó vezetékek

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2024-02-01

Forrás

idt EN 50341-2-7:2023

Előd

MSZ EN 50341-2-7:2016

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 1593803) ,

oldalszáma

33 oldal; Q kategória

ára

Nettó: 13160 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 16582 Ft
PDF (letöltés) formátum esetén (27% Áfával): 16713 Ft