Hivatkozási szám

MSZ EN ISO 5167-6:2023

Dokumentumazonosító

181243

Cím

Folyadékáram-mérés nyomáskülönbség elvén működő eszközökkel, olyan, kör keresztmetszetű csővezetékben, amelyet az áramló anyag teljes keresztmetszetében kitölt. 6. rész: Ék alakú, szűkítéses áramlásmérők (ISO 5167-6:2022)

Angol cím

Measurement of fluid flow by means of pressure differential devices inserted in circular cross-section conduits running full. Part 6: Wedge meters (ISO 5167-6:2022)

Alkalmazási terület

This document specifies the geometry and method of use (installation and operating conditions) of wedge meters when they are inserted in a conduit running full to determine the flow rate of the fluid flowing in the conduit. NOTE 1 As the uncertainty of an uncalibrated wedge meter can be too large for a particular application, it could be deemed essential to calibrate the flow meter according to Clause 7. This document gives requirements for calibration which, if applied, are for use over the calibrated Reynolds number range. Clause 7 could also be useful guidance for calibration of meters of similar design but which fall outside the scope of this document. It also provides background information for calculating the flow rate and is applicable in conjunction with the requirements given in ISO 5167-1. This document is applicable only to wedge meters in which the flow remains subsonic throughout the measuring section and where the fluid can be considered as single-phase. Uncalibrated wedge meters can only be used within specified limits of pipe size, roughness, ß (or wedge ratio) and Reynolds number. It is not applicable to the measurement of pulsating flow. It does not cover the use of uncalibrated wedge meters in pipes whose internal diameter is less than 50 mm or more than 600 mm, or where the pipe Reynolds numbers are below 1 × 104. NOTE 2 A wedge meter has a primary element which consists of a wedge-shaped restriction of a specific geometry. Alternative designs of wedge meters are available; however, at the time of writing there is insufficient data to fully characterize these devices, and therefore these meters are calibrated in accordance with Clause 7.

ICS

17.120.10 Áramlás zárt vezetékekben

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2023-04-01

Forrás

idt EN ISO 5167-6:2022; idt ISO 5167-6:2022

Előd

MSZ EN ISO 5167-6:2020

Utód

Módosítás

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 942603) ,

oldalszáma

21 oldal; L kategória

ára

Nettó: 10600 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 13356 Ft
PDF (letöltés) formátum esetén (27% Áfával): 13462 Ft