Szabványkereső

Hivatkozási szám, azonosító jelzet, vagy a szabványcímben előforduló kulcsszó szerinti keresés:


ICS (a szabványok nemzetközi osztályozási rendszere) szerinti keresés

Nettó ár: 12520 Ft
Kosárba tesz
Alapadatok
Hivatkozási szám
MSZ EN 1253-6:2023
Dokumentumazonosító
181070
Cím
Épületen belüli padlóösszefolyók. 6. rész: 50 mm-nél kisebb vízzármagasságú, nedves bűzzárral ellátott padlóösszefolyók
Angol cím
Gullies for buildings. Part 6: Trapped floor gullies with a depth of water seal less than 50 mm
Alkalmazási terület
This document classifies floor gullies for domestic waste water for use inside buildings, gives guidance for places of installation and specifies requirements for the construction, design, performance and marking of factory made gullies for buildings, irrespective of the material, for use in drainage systems requiring a trap with a depth of water seal less than 50 mm (referred to as floor gullies). NOTE Floor gullies with a depth of water seal less than 50 mm are not covered by EN 1253-1, EN 1253-7 and EN 1253-8. These products are intended to be installed where the three following conditions are met: — space limitation will not accommodate a gully with a 50 mm water seal; — the building does not exceed a ground-floor and three floors above; — at least two domestic sanitary appliances are installed in addition to the gully but with only one WC on the same branch (connection pipe) or secondary or branch ventilation is installed (see EN 12056-2:2000, 4.3.2 or 4.3.4.
ICS
91.140.80 Vízelvezető rendszerek
A szabvány nyelve
angol
Az érvényesség kezdete
2023-03-01
További adatok
Forrás
idt EN 1253-6:2022
Előd
Utód
Módosítás
SZK-közlemények
Kapcsolódó európai jogszabály
Kereskedelmi adatok
A szabvány
kapható formátuma
Papír ,
PDF (letöltés) (a fájl mérete: 918755) ,
oldalszáma
31 oldal; P kategória
ára
Nettó: 12520 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 15775 Ft
PDF (letöltés) formátum esetén (27% Áfával): 15900 Ft
Szabvány életútja
Elődök

Jelenleg nincsenek előzmények

Megtekintett szabvány

MSZ EN 1253-6:2023

2023-03-01

Utódok

Jelenleg nincsenek utódok