Szabványkereső

Hivatkozási szám, azonosító jelzet, vagy a szabványcímben előforduló kulcsszó szerinti keresés:


ICS (a szabványok nemzetközi osztályozási rendszere) szerinti keresés

Nettó ár: 23380 Ft
Kosárba tesz
Alapadatok
Hivatkozási szám
MSZ EN 15502-2-1:2023
Dokumentumazonosító
180765
Cím
Gáztüzelésű központi fűtési kazánok. 2-1. rész: A legfeljebb 1000 kW névleges hőterhelésű C típusú, valamint B2, B3 és B5 típusú kazánok egyedi előírásai
Angol cím
Gas-fired central heating boilers. Part 2-1: Specific standard for type C appliances and type B2, B3 and B5 appliances of a nominal heat input not exceeding 1 000 kW
Alkalmazási terület
This document specifies the requirements and test methods, as well as the classification and marking of gas-fired central heating boilers that are fitted with atmospheric burners, fan assisted atmospheric burners or fully premixed burners, and are hereafter referred to as “boilers”. This document is intended to be used in conjunction with EN 15502-1:2021. This document covers gas-fired central heating boilers from the types C1 up to C(11) and the types B2, B3 and B5: NOTE 1 For further background information on appliance types see EN 1749:2020. a) that have a nominal heat input (on the basis of net calorific value) not exceeding 1 000 kW; b) that use one or more combustible gases of the three gas families at the pressures stated in EN 437:2021; c) where the temperature of the heat transfer fluid does not exceed 105 °C during normal operation; d) where the maximum operating pressure in the water circuit does not exceed 6 bar; e) which can give rise to condensation under certain circumstances; f) which are declared in the instructions for installation to be either a “condensing” boiler or a “low temperature boiler” or a “standard boiler”; if no declaration is given the boiler is to be considered a “standard boiler”; g) which are intended to be installed inside a building or in a partially protected place; h) which are intended to produce also hot water either by the instantaneous or storage principle as a single unit; i) which are designed for either sealed water systems or for open water systems; j) which are either modular boilers, or non-modular boilers. k) which are from the types C(10) that are equipped with a gas-air ratio control and that have a ?pmax, saf(min) of 25 Pa, and C(11) that have condensing boiler modules that are equipped with a gas-air ratio control and that have a ?pmax, saf(min) of 25 Pa. NOTE 2 This document provides requirements for boilers with known constructions. For boilers with any alternative constructions, which might not fully be covered by this standard, the risk associated with this alternative construction needs to be assessed. An example of an assessment methodology, based upon risk assessment, is given in Clause 11. This document does not cover all the requirements for: aa) appliances above 1 000 kW; ab) appliances that are intended to be connected to gas grids where the quality of the distributed gas is likely to vary to a large extent over the lifetime of the appliance (see Annex AB of EN 15502-1:2021); ac) appliances using flue dampers; ad) appliances of the types B21, B31, B51, C21, C41, C51, C61, C71, C81, C(12) and C(13); ae) C7 appliances that have a nominal heat input (on the basis of net calorific value) exceeding 70 kW; Túl hosszú scope
ICS
27.060.30 Kazánok és hőcserélők
91.140.10 Központi fűtési rendszerek
Műszaki Bizottság
A szabvány nyelve
angol
Az érvényesség kezdete
2023-01-01
További adatok
Forrás
idt EN 15502-2-1:2022
Utód
Módosítás
SZK-közlemények
Kapcsolódó európai jogszabály
92/42/EGK A TANÁCS 92/42/EK IRÁNYELVE (1992. május 21.) a folyékony vagy gáznemű tüzelő anyaggal működő új melegvízkazánok hatásfok-követelményeiről (HWB); (E-E06); (E-E07); 2016/426/EU (GAS16)
Kereskedelmi adatok
A szabvány
kapható formátuma
Papír ,
PDF (letöltés) (a fájl mérete: 3508205) ,
oldalszáma
108 oldal; XA kategória
ára
Nettó: 23380 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 29459 Ft
PDF (letöltés) formátum esetén (27% Áfával): 29693 Ft
Szabvány életútja
Megtekintett szabvány

MSZ EN 15502-2-1:2023

2023-01-01

Utódok

Jelenleg nincsenek utódok