Hivatkozási szám

MSZ EN ISO 3251:2009

Dokumentumazonosító

646778

Cím

Festékek, lakkok és műanyagok. A nemillóanyag-tartalom meghatározása (ISO 3251:2008)

Angol cím

Paints, varnishes and plastics. Determination of non-volatile-matter content (ISO 3251:2008)

Alkalmazási terület

This International Standard specifies a method for determining the non-volatile-matter content by mass of paints, varnishes, binders for paints and varnishes, polymer dispersions and condensation resins such as phenolic resins (resols, novolak solutions, etc.). The method is also applicable to formulated dispersions containing fillers, pigments and other auxiliaries (e.g. thickeners and film-forming agents). For the method to be usable for unplasticized polymer dispersions and rubber latices, the non-volatile residue (which consists essentially of the polymeric material and of small quantities of auxiliaries such as emulsifiers, protective colloids, stabilizers, solvents added as film-forming agents and — especially for rubber latex concentrate — preserving agents) has to be chemically stable under the test conditions. For plasticized samples, the residue, by definition, normally includes the plasticizer. NOTE 1 The non-volatile-matter content of a product is not an absolute quantity but depends upon the temperature and period of heating used for the determination. Consequently, when using this method, only relative and not true values for non-volatile-matter content are obtained owing to solvent retention, thermal decomposition and evaporation of low molecular mass constituents. The method is therefore primarily intended for testing different batches of the same type of product. NOTE 2 This method is suitable for synthetic rubber latices provided heating for a specific period of time is considered appropriate (ISO 124 specifies heating until the loss in mass of a 2 g test portion following successive periods of heating is less than 0,5 mg). NOTE 3 In-house methods for determining non-volatile matter often include drying with infrared or microwave radiation. Standardization of such methods is not possible, since they are not generally applicable. Some polymer compositions tend to decompose during such treatment and therefore give incorrect results. ISO 3233 and ISO 23811 specify methods for determining the volume of non-volatile matter in paints, varnishes and related products.

ICS

83.080.01 Műanyagok általában

87.040 Festékek és lakkok

87.060.20 Kötőanyagok

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2009-01-01

A visszavonás napja

2019-12-01

Forrás

idt EN ISO 3251:2008; idt ISO 3251:2008

Előd

MSZ EN ISO 3251:2003

Utód

MSZ EN ISO 3251:2019

Módosítás

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 278850) ,

oldalszáma

11 oldal; F kategória

ára

Nettó: 7300 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 9198 Ft
PDF (letöltés) formátum esetén (27% Áfával): 9271 Ft