Hivatkozási szám

MSZ EN ISO 20042:2022

Dokumentumazonosító

178047

Cím

A radioaktivitás mérése. Gamma-sugárzó radionuklidok. Általános vizsgálati módszer gamma-spektrometriával (ISO 20042:2019)

Angol cím

Measurement of radioactivity. Gamma-ray emitting radionuclides. Generic test method using gamma-ray spectrometry (ISO 20042:2019)

Alkalmazási terület

This document describes the methods for determining the activity in becquerel (Bq) of gamma-ray emitting radionuclides in test samples by gamma-ray spectrometry. The measurements are carried out in a testing laboratory following proper sample preparation. The test samples can be solid, liquid or gaseous. Applications include: — routine surveillance of radioactivity released from nuclear installations or from sites discharging enhanced levels of naturally occurring radioactive materials; — contributing to determining the evolution of radioactivity in the environment; — investigating accident and incident situations, in order to plan remedial actions and monitor their effectiveness; — assessment of potentially contaminated waste materials from nuclear decommissioning activities; — surveillance of radioactive contamination in media such as soils, foodstuffs, potable water, groundwaters, seawater or sewage sludge; — measurements for estimating the intake (inhalation, ingestion or injection) of activity of gamma-ray emitting radionuclides in the body. It is assumed that the user of this document has been given information on the composition of the test sample or the site. In some cases, the radionuclides for analysis have also been specified if characteristic limits are needed. It is also assumed that the test sample has been homogenised and is representative of the material under test. General guidance is included for preparing the samples for measurement. However, some types of sample are to be prepared following the requirements of specific standards referred to in this document. The generic recommendations can also be useful for the measurement of gamma-ray emitters in situ. This document includes generic advice on equipment selection (see Annex A), detectors (more detailed information is included in Annex D), and commissioning of instrumentation and method validation. Annex F summarises the influence of different measurement parameters on results for a typical gamma-ray spectrometry system. Quality control and routine maintenance are also covered, but electrical testing of the detector and pulse processing electronics is excluded. It is assumed that any data collection and analysis software used has been written and tested in accordance with relevant software standards such as ISO/IEC/IEEE 12207. Calibration using reference sources and/or numerical methods is covered, including verification of the results. It also covers the procedure to estimate the activity content of the sample (Bq) from the spectrum. The principles set out in this document are applicable to measurements by gamma-ray spectrometry in testing laboratories and in situ. However, the detailed requirements for in situ measurement are given in ISO 18589-7 and are outside the scope of this document. This document covers, but is not restricted to, gamma-ray emitters which emit photons in the energy range of 5 keV to 3 000 keV. However, most of the measurements fall into the range 40 keV to 2 000 keV. The activity (Bq) ranges from the low levels (sub-Bq) found in environmental samples to activities found in accident conditions and high level radioactive wastes.

ICS

13.280 Sugárvédelem

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2022-02-01

Forrás

idt ISO 20042:2019; idt EN ISO 20042:2021

Előd

Utód

Módosítás

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 2509728) ,

oldalszáma

61 oldal; X kategória

ára

Nettó: 21330 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 26876 Ft
PDF (letöltés) formátum esetén (27% Áfával): 27089 Ft