Hivatkozási szám

MSZ EN 17176-5:2019

Dokumentumazonosító

173327

Cím

Műanyag csővezetékrendszerek vízellátáshoz, valamint nyomás alatti, földbe fektetett és föld feletti alagcsövezéshez és csatornázáshoz. Orientált kemény poli(vinil-klorid) (PVC-O). 5. rész: A rendszer céljának való megfelelés

Angol cím

Plastics piping systems for water supply and for buried and above ground drainage, sewerage and irrigation under pressure. Oriented unplasticized poly(vinyl chloride) (PVC-O). Part 5: Fitness for purpose of the system

Alkalmazási terület

This part of EN 17176 specifies the characteristics of the fitness for purpose of oriented unplasticized poly(vinyl chloride) (PVC-O) solid wall piping systems intended for water supply and for buried drainage, sewerage, treated waste water and irrigation under pressure or above-ground where protected from direct sunlight. It also specifies the test parameters for the test methods referred to in this document. NOTE 1 This document is not intended for on-site testing of pipe systems. In conjunction with EN 17176-1, EN 17176-2, CEN/TS 17176-3 and EN ISO 1452-3, it is applicable to PVC-O pipes, PVC-O fittings, their joints and to joints with components of other plastics and non-plastics materials intended to be used for the following: a) water mains and services lines; b) conveyance of water for both outside and inside buildings; c) drainage and sewerage under pressure; d) irrigation under pressure. Joints constructed of other materials shall meet their own standards in addition to the fitness of purpose requirements specified in this document. It is applicable to piping systems intended for the supply of water with a maximum allowable operating pressure (PFA) up to and including 25 bar1). The piping system according to this document is intended for the conveyance of cold water up to and including 45 °C and especially in those applications where special performance requirements are needed, such as impact loads and pressure fluctuations. For temperatures between 25 °C and 45 °C, EN 17176-2:2019, Figure C.1 applies. NOTE 2 It is the responsibility of the purchaser or specifier to make the appropriate selections from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.

ICS

23.040.20 Műanyag csövek

23.040.45 Műanyag csőidomok

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2019-11-01

Forrás

idt EN 17176-5:2019

Előd

Utód

Módosítás

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 651121) ,

oldalszáma

14 oldal; G kategória

ára

Nettó: 8000 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 10080 Ft
PDF (letöltés) formátum esetén (27% Áfával): 10160 Ft