Hivatkozási szám

MSZ EN 17059:2018

Dokumentumazonosító

169615

Cím

Galvanizáló és anódizáló sorok. Biztonsági követelmények

Angol cím

Plating and anodizing lines. Safety requirements

Alkalmazási terület

This document describes all significant hazards, hazardous situations and events relating to plating and anodizing lines, when used as intended and in compliance with the foreseeable conditions of the manufacturer. In addition, procedures for testing and measuring safety requirements, marking of equipment and minimum operation requirements are specified. For reference to plating lines and anodizing lines the term plating line is used in this document. This document applies to the design and construction of plating lines and anodizing lines including their transporter systems for surface treatment of industrial products by means of inorganic or organic electrolytes or by means of other process chemistries. Plating lines and anodizing lines in terms of this standard are arrangements of process tanks for: — electrolytic treatment of work pieces (e.g. electrocleaning, passivation, electroetching, burnishing, electrolytic polishing and brightening, drying); — wet chemical treatment of work pieces (e.g. degreasing, passivation, chemical polishing, etching, pickling, blackening); — electrolytic and electro-less metal deposition, even on non-metallic work pieces made electrically conductive by corresponding treatment; — changing of substance composition on the surface of metallic work pieces e.g. burnishing, blackening, phosphatizing, chromating and; — anodizing (anodic oxidation); including rinsing tanks and the corresponding transporter equipment (e.g. transporter systems, handling gantry, bean, etc.), where the products are lifted in and out of tanks. This document distinguishes between the following types of plating lines: — Type 1: manual lines; — Type 2: semi-automatic lines; — Type 3: fully automatic lines. Furthermore, it specifies equipment marking and requirements on user information. This document does not deal with hazards resulting from plating linesparts above category 1 of PED (Pressure Equipment Directive). This document is not applicable to: — transporter systems of carrousel lines (see EN 618 and EN 15095); — equipment for the preparation and treatment of water and waste water; — machinery for dip coating and electro-deposition of organic liquid coating material (EN 12581); — horizontal plating lines (e.g. printed circuit board, etching, reel to reel, continuous plating lines); — machinery for surface cleaning and surface pre-treatment of industrial items using liquids or vapours (EN 12921-1, EN 12921-2, EN 12921-3, EN 12921-4). NOTE Machinery for surface cleaning and surface pre-treatment (EN 12921 series) could be part of a plating line.

ICS

25.220.20 Felületkezelés

A szabvány nyelve

angol

Az érvényesség kezdete

2018-11-01

Forrás

idt EN 17059:2018

Előd

MSZ-05-20.0510-4:1989

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

2006/42/EK AZ EURÓPAI PARLAMENT ÉS A TANÁCS 2006/42/EK IRÁNYELVE (2006. május 17.) a gépekről és a 95/16/EK irányelv módosításáról (átdolgozás) (EGT vonatkozású szöveg) (MAC06)

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 16168197) ,

oldalszáma

78 oldal; W kategória

ára

Nettó: 19470 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 24532 Ft
PDF (letöltés) formátum esetén (27% Áfával): 24727 Ft