Hivatkozási szám

MSZ EN ISO 17892-6:2017

Dokumentumazonosító

165930

Cím

Geotechnikai vizsgálatok. Talajok laboratóriumi vizsgálata. 6. rész: Ejtőkúpos vizsgálat (ISO 17892-6:2017)

Angol cím

Geotechnical investigation and testing. Laboratory testing of soil. Part 6: Fall cone test (ISO 17892-6:2017)

Alkalmazási terület

This document specifies a method of undrained strength index testing of both undisturbed and remoulded specimens of fine grained soils by the fall cone method. This document is applicable to the laboratory estimation of undrained shear strength of a soil test specimen within the scope of geotechnical investigations. In the fall cone test, a cone is allowed to fall with its tip towards a soil specimen, and the resulting penetration of the cone into the soil is measured. The penetration values are used to estimate the undrained shear strength. The fall cone test produces a complex shear in the test specimen, and does not represent either a vertical triaxial compression or a horizontal shear test. However, this index test may be correlated to some estimate of undrained shear strength determined in the laboratory by other test methods. As the test is performed on a small laboratory specimen, the result may not agree with laboratory tests on larger specimens. In addition, the test specimen may not be fully representative of the soil in its natural state in the field; for example, the test specimen may not have fissures present in situ at a larger spacing than the specimen size. Therefore, for the above reasons, the test can be regarded as an estimation of undrained shear strength, rather than a true measurement of it. The ratio of the remoulded shear strength to the undisturbed shear strength may be used to estimate the sensitivity of a soil specimen. Time-dependent measurement of the shear strength may be used to assess the thixotropic regain of strength of a remoulded soil specimen. NOTE This document fulfils the requirements of the strength index testing of soils for geotechnical investigation and testing in accordance with EN 1997–1 and EN 1997–2.

ICS

13.080.20 Talaj fizikai tulajdonságai

93.020 Földmunkák. Földkiemelés. Alapozásépítés. Föld alatti munkák

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2017-08-01

Forrás

idt EN ISO 17892-6:2017; idt ISO 17892-6:2017

Előd

MSZE CEN ISO/TS 17892-6:2010

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 555517) ,

oldalszáma

20 oldal; K kategória

ára

Nettó: 9880 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 12449 Ft
PDF (letöltés) formátum esetén (27% Áfával): 12548 Ft