Hivatkozási szám

MSZ EN ISO 5163:2014

Dokumentumazonosító

158556

Cím

Ásványolajtermékek. A motor- és repülőgép-hajtóanyagok oktánszámának meghatározása. Motormódszer (ISO 5163:2014)

Angol cím

Petroleum products. Determination of knock characteristics of motor and aviation fuels. Motor method (ISO 5163:2014)

Alkalmazási terület

This International Standard establishes the rating of liquid spark-ignition engine fuel in terms of an arbitrary scale of octane numbers using a standard single-cylinder, four-stroke cycle, variablecompression ratio, carburetted, CFR engine operated at constant speed. Motor octane number (MON) provides a measure of the knock characteristics of motor fuels in automotive engines under severe conditions of operation. The motor octane number provides a measure of the knock characteristics of aviation fuels in aviation piston engines, by using an equation to correlate to aviation-method octane number or performance number (lean-mixture aviation rating). This International Standard is applicable for the entire scale range from 0 MON to 120 MON, but the working range is 40 MON to 120 MON. Typical motor fuel testing is in the range of 80 MON to 90 MON. Typical aviation fuel testing is in the range of 98 MON to 102 MON. This International Standard is applicable for oxygenate-containing fuels containing up to 4,0 % (m/m) oxygen and for gasoline containing up to 25 % (V/V) ethanol. NOTE 1 Although 25 % (V/V) of ethanol corresponds to approximately 9 % (m/m) oxygen, full applicability of this test method for that oxygen range has only been checked for gasoline type of fuels. NOTE 2 Work is under way to check the possibility to use the method for gasoline containing up to 85 % (V/V) ethanol. NOTE 3 This International Standard specifies operating conditions in SI units but engine measurements may be specified in inch-pound units because these were the units used in the manufacture of the equipment, and thus some references in this International Standard include these units in parenthesis. NOTE 4 For the purposes of this standard, the terms “% (m/m)” and “% (V/V)” are used to represent the mass fraction, µ, and the volume fraction, ?, of a material respectively

ICS

75.160.20 Folyékony tüzelőanyagok

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2014-09-01

Forrás

idt EN ISO 5163:2014; idt ISO 5163:2014

Előd

MSZ EN ISO 5163:2006

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 675229) ,

oldalszáma

32 oldal; P kategória

ára

Nettó: 12520 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 15775 Ft
PDF (letöltés) formátum esetén (27% Áfával): 15900 Ft