Hivatkozási szám

MSZ EN 61290-3-3:2014

Dokumentumazonosító

157920

Cím

Optikai erősítők. Vizsgálati módszerek. 3-3. rész: Zajtényező-paraméterek. A jel-teljesítmény és a teljes ASE-teljesítmény aránya (IEC 61290-3-3:2013)

Angol cím

Optical amplifiers. Test methods. Part 3-3: Noise figure parameters. Signal power to total ASE power ratio (IEC 61290-3-3:2013)

Alkalmazási terület

This part of IEC 61290-3 applies to all commercially available single channel optical amplifiers (OAs), including OAs using optically pumped fibres (OFAs) based on either rare-earth doped fibres or on the Raman effect, semiconductor optical amplifier modules (SOA modules) and planar optical waveguide amplifiers (POWAs). More specifically, it applies to single channel OAs placed before optical receivers, where there are no optical bandpass filtering elements placed between the OA and the receiver. The object of this part of IEC 61290-3 is to establish uniform requirements for accurate and reliable measurement of the ratio of the signal output power to the total ASE power generated by the OA in the optical bandwidth of the receiver. This quantity is a measure of the spontaneous-spontaneous beat noise at the receiver, and is correlated to the spontaneousspontaneous noise factor of the OA, Fsp-sp, as defined in IEC 61290-3 and IEC 61291-1. IEC 61290-3-1 describes a measurement method, using an optical spectrum analyzer, OSA, for the signal-spontaneous noise factor Fsig-sp but does not describe a method for measuring Fsp-sp. IEC 61290-3-2 describes a measurement method, using an electrical spectrum analyzer (ESA), for the total noise factor Fsp-sp + Fsig-sp. However, this method does not allow Fsp-sp to be measured separately, and therefore does not provide a means of directly quantifying the effect of spontaneous-spontaneous beat noise at the receiver. This part of IEC 61290-3 complements IEC 61290-3-1 and IEC 61290-3-2 in that it provides such a means. Two measurement methods are provided for the ratio of the signal output power to the total ASE power. The first method uses an OSA, while the second method uses a bandpass filter and an optical power meter.

ICS

33.180.30 Optikai erősítők

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2014-05-01

Forrás

idt EN 61290-3-3:2014; idt IEC 61290-3-3:2013

Előd

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 452596) ,

oldalszáma

18 oldal; XY kategória

ára

Nettó: 10250 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 12915 Ft
PDF (letöltés) formátum esetén (27% Áfával): 13018 Ft