Hivatkozási szám

MSZ EN 14315-1:2013

Dokumentumazonosító

156215

Cím

Hőszigetelő termékek épületekhez. Helyszínen kialakított, szórt, merev poliuretánhab (PUR) és poliizocianuráthab (PIR) hőszigetelés. 1. rész: A beépítendő szórt, merev habrendszer előírásai

Angol cím

Thermal insulating products for buildings. In-situ formed sprayed rigid polyurethane (PUR) and polyisocyanurate (PIR) foam products. Part 1: Specification for the rigid foam spray system before installation

Alkalmazási terület

This European Standard specifies requirements for in-situ formed sprayed rigid polyurethane (PUR) and rigid polyisocyanurate (PIR) foam products when applied to walls, ceilings, roofs, suspended ceilings and floors. This Part 1 of this European Standard is a specification for the rigid foam spray system before installation. Part 1 of this European Standard describes the product characteristics and includes procedures for testing, marking and labelling and the rules for evaluation of conformity. This European Standard does not specify the required levels of all properties to be achieved by a product to demonstrate fitness for purpose in a particular end-use application. The required levels are to be found in regulations or non-conflicting standards. This European Standard does not cover factory made rigid polyurethane (PUR) or polyisocyanurate (PIR) foam insulation products or in-situ products intended to be used for the insulation of building equipment and industrial installations. NOTE Foam products are either called flexible or rigid. The flexible products are used in upholstery and mattresses and are characterised by their ability to deflect, support and recover to their original thickness continually during their inuse phase. Those that are not flexible are termed rigid and do not possess these flexible characteristics. They are mostly used for thermal insulation purposes and vary widely in their compression strength values. Once the cell structure is crushed in a rigid foam, it does not recover its thickness fully. Some of these rigid foams are very low in density with very low compression strengths and are sometimes described “commercially” as “soft foams” or “semi-rigid” foams. This note has been included to clarify that all foams with such descriptions are covered by this standard’s used of the term rigid foam.

ICS

91.100.60 Hő- és hangszigetelő anyagok

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2013-08-01

Forrás

idt EN 14315-1:2013

Előd

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

89/106/EGK; (CPR89); 305/2011/EU; (CPR11)

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 1262111) ,

oldalszáma

65 oldal; V kategória

ára

Nettó: 18390 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 23171 Ft
PDF (letöltés) formátum esetén (27% Áfával): 23355 Ft