Hivatkozási szám

MSZ EN ISO 12846:2013

Dokumentumazonosító

155005

Cím

Vízminőség. Higanymeghatározás. Atomabszorpciós spektrometria (AAS) dúsítással és dúsítás nélkül (ISO 12846:2012)

Angol cím

Water quality. Determination of mercury. Method using atomic absorption spectrometry (AAS) with and without enrichment (ISO 12846:2012)

Alkalmazási terület

This International Standard specifies two methods for the determination of mercury in drinking, surface, ground, rain and waste water after appropriate pre-digestion. For the first method (described in Clause 6), an enrichment step by amalgamation of the Hg on, for example, a gold/platinum adsorber is used. For the method given in Clause 7, the enrichment step is omitted. The choice of method depends on the equipment available, the matrix and the concentration range of interest. Both methods are suitable for the determination of mercury in water. The method with enrichment (see Clause 6) commonly has a practical working range from 0,01 µg/l to 1 µg/l. The mean limit of quantification (LOQ) reported by the participants of the validation trial (see Annex A) was 0,008 µg/l. This information on the LOQ gives the user of this International Standard an orientation and does not replace the estimation of performance data based on laboratory-specific data. It has to be considered that it is possible to achieve lower LOQs with specific instrumentation (e.g. single mercury analysers). The method without enrichment (in Clause 7) commonly has a practical working range starting at 0,05 µg/l. The LOQ reported by the participants of the validation trial (see Annex A) was 0,024 µg/l. It is up to the user, based on the specific application, to decide whether higher concentrations are determined by omitting the enrichment step and/or by diluting the sample(s). The sensitivity of both methods is dependent on the selected operating conditions. Another possibility for the determination of extremely low Hg concentrations down to 0,002 µg/l without pre-concentration is the application of atomic fluorescence spectrometry (see ISO 17852). Specific atomicabsorption mercury analysers allow determinations down to 0,010 µg/l without pre-concentration. In general, the determination of trace concentrations of Hg by AAS (or AFS) is dependent on clean operating conditions in the laboratory and on the use of high-purity chemicals with negligible low-Hg blanks. NOTE This International Standard may be applied to industrial and municipal waste water after an additional digestion step performed under appropriate conditions and after suitable method validation (see 7.4). A potential sample stability issue (mercury loss) for anaerobic reducing industrial effluents has to be considered thoroughly.

ICS

13.060.50 Vízvizsgálat vegyi anyagokra

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2013-03-01

Forrás

idt EN ISO 12846:2012; idt ISO 12846:2012

Előd

MSZ EN 12338:2000, MSZ EN 1483:2007

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 470916) ,

oldalszáma

19 oldal; K kategória

ára

Nettó: 9880 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 12449 Ft
PDF (letöltés) formátum esetén (27% Áfával): 12548 Ft