Hivatkozási szám

MSZ EN 60865-1:2012

Dokumentumazonosító

154544

Cím

Zárlati áramok. Hatásszámítások. 1. rész. Fogalommeghatározások és számítási módszerek (IEC 60865-1:2011)

Angol cím

Short-circuit currents. Calculation of effects. Part 1: Definitions and calculation methods (IEC 60865-1:2011)

Alkalmazási terület

This part of IEC 60865 is applicable to the mechanical and thermal effects of short-circuit currents. It contains procedures for the calculation of – the electromagnetic effect on rigid conductors and flexible conductors, – the thermal effect on bare conductors. For cables and insulated conductors, reference is made, for example, to IEC 60949 and IEC 60986. For the electromagnetic and thermal effects in d.c. auxiliary installations of power plants and substations reference is made to IEC 61660-2. Only a.c. systems are dealt with in this standard. The following points should, in particular, be noted: a) The calculation of short-circuit currents should be based on IEC 60909. For the determination of the greatest possible short-circuit current, additional information from other IEC standards may be referred to, e.g. details about the underlying circuitry of the calculation or details about current-limiting devices, if this leads to a reduction of the mechanical stress. b) Short-circuit duration used in this standard depends on the protection concept and should be considered in that sense. c) These standardized procedures are adjusted to practical requirements and contain simplifications which are conservative. Testing or more detailed methods of calculation or both may be used. d) In Clause 5 of this standard, for arrangements with rigid conductors, only the stresses caused by short-circuit currents are calculated. Furthermore, other stresses can exist, e.g. caused by dead-load, wind, ice, operating forces or earthquakes. The combination of these loads with the short-circuit loading should be part of an agreement and/or be given by standards, e.g. erection-codes. The tensile forces in arrangements with flexible conductors include the effects of deadload. With respect to the combination of other loads the considerations given above are valid. e) The calculated loads are design loads and should be used as exceptional loads without any additional partial safety factor according to installation codes of, for example, IEC 61936-1 [1]1.

ICS

17.220.01 Villamosság. Mágnesség. Általános szempontok

29.240.20 Energiaátviteli és -elosztó vezetékek

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2012-11-01

Forrás

idt EN 60865-1:2012; idt IEC 60865-1:2011

Előd

MSZ EN 60865-1:1997

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 1400445) ,

oldalszáma

52 oldal; U kategória

ára

Nettó: 17420 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 21949 Ft
PDF (letöltés) formátum esetén (27% Áfával): 22123 Ft