Hivatkozási szám

MSZ EN 14303:2010

Dokumentumazonosító

149143

Cím

Épületgépészeti és ipari hőszigetelő termékek. Gyári készítésű ásványgyapot (MW-) termékek. Műszaki előírások

Angol cím

Thermal insulation products for building equipment and industrial installations. Factory made mineral wool (MW) products. Specification

Alkalmazási terület

This European Standard specifies the requirements for factory made mineral wool products, which are used for the thermal insulation of building equipment and industrial installations with an operating temperature range of approximately 0 °C to + 800 °C. NOTE Below an operating temperature of ambient, special means against water vapour diffusion and water accumulation by air flow might be required. Below an operating temperature of - 50 ?C, special tests regarding the suitability of the products in the intended application are advised (e.g. liquefaction of oxygen). Manufacturer's advice should be heeded in all cases. The products are manufactured with or without facings or coatings, in the form of rolls, boards, slabs, mats, felts, quilts, wired mats, lamella mats, bevelled lags and pipe sections. This European Standard describes product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling. Products covered by this standard are also used in prefabricated thermal insulation systems and composite panels; the performance of systems incorporating these products is not covered. This European Standard does not specify the required level of a given property that shall be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application can be found in regulations and invitations to tender. Products with a declared thermal conductivity greater than 0,065 W/(m•K) at 10 °C are not covered by this standard. This Eurpean Standard does not cover products for in situ insulation (blowing or pouring) or products for the insulation of the building structure. This European Standard does not cover the following acoustical aspects: direct airborne sound insulation and impact noise transmission index.

ICS

91.100.60 Hő- és hangszigetelő anyagok

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2010-03-01

A visszavonás napja

2013-08-01

Forrás

idt EN 14303:2009

Előd

Utód

MSZ EN 14303:2009+A1:2013

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 469978) ,

oldalszáma

36 oldal; R kategória

ára

Nettó: 14180 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 17867 Ft
PDF (letöltés) formátum esetén (27% Áfával): 18009 Ft