Hivatkozási szám

MSZ EN 598:2007+A1:2009

Dokumentumazonosító

148339

Cím

Gömbgrafitos öntöttvas csövek, csőidomok, tartozékok és azok kötései csatornázáshoz. Követelmények és vizsgálati módszerek

Angol cím

Ductile iron pipes, fittings, accessories and their joints for sewerage applications. Requirements and test methods

Alkalmazási terület

This European Standard specifies the requirements and associated test methods applicable to ductile iron pipes, fittings, accessories and their joints for the construction of drains and sewers outside buildings: - operating without pressure (gravity sewerage), or with positive or negative pressure (see Table 5); - to be installed below or above ground; - to convey surface water, domestic waste water and certain types of industrial effluents, either in separate systems or in combined systems. This European Standard applies to pipes, fittings and accessories which are: - manufactured with socketed, flanged or spigot ends; - normally delivered externally and internally coated; - suitable for continuous fluid temperatures between 0 °C excluding frost, and 45 °C for DN - 200 or 35 °C for DN - 200, according to EN 476; - not intended for use in areas subject to reaction to fire regulations. NOTE 1 This does not preclude special arrangements for the products to be used at higher temperatures. This European Standard covers pipes, fittings and accessories cast by any type of foundry process or manufactured by fabrication of cast components, as well as corresponding joints, of a size range extending from DN 80 to DN 2000 inclusive. This European Standard specifies requirements for materials, dimensions and tolerances, mechanical properties and standard coatings of ductile iron pipes and fittings. It also gives performance requirements for all components including joints. Joint design and gasket shapes are outside the scope of this European Standard. NOTE 2 In this European Standard, all pressures are relative pressures, expressed in bars (100 kPa = 1 bar).

ICS

23.040.05 Csővezetékek és külső csatornaelemeik rendszere

23.040.10 Vas- és acélcsövek

23.040.40 Fém csőidomok

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2009-10-01

Forrás

idt EN 598:2007+A1:2009

Előd

MSZ EN 598:2008

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

305/2011/EU; (CPR11); 89/106/EGK; (CPR89)

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 651314) ,

oldalszáma

67 oldal; V kategória

ára

Nettó: 18390 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 23171 Ft
PDF (letöltés) formátum esetén (27% Áfával): 23355 Ft