Hivatkozási szám

MSZ EN 61290-11-1:2009

Dokumentumazonosító

146805

Cím

Optikai erősítők. Vizsgálati módszerek. 11-1. rész: Polarizációs módusdiszperziós paraméter. Jones-mátrixos sajátvektor-analízis (JME) (IEC 61290-11-1:2008)

Angol cím

Optical amplifiers. Test methods. Part 11-1: Polarization mode dispersion parameter. Jones matrix eigenanalysis (JME) (IEC 61290-11-1:2008)

Alkalmazási terület

This part of IEC 61290 applies to all commercially available optical amplifiers (OAs), including optical fibre amplifiers (OFAs) using active fibres, semiconductor optical amplifiers (SOAs), and planar waveguide optical amplifiers (PWOAs). Polarization-mode dispersion (PMD) causes an optical pulse to spread in the time domain. This dispersion could impair the performance of a telecommunications system. The effect can be related to differential group velocity and corresponding arrival times of different polarization components of the signal. For a narrowband source, the effect can be related to a differential group delay (DGD) between pairs of orthogonally polarized principal states of polarization (PSP). Other information about PMD may be found in IEC 61282-9 in general and in IEC 61292-5 on OAs in particular. This test method describes a procedure for measuring the PMD of OAs. The measurement result is obtained from the measurement of the normalized Stokes parameters at two closely spaced wavelengths. The test method described herein requires a polarized signal at the input of the polarimeter with a degree of polarization (DOP) of at least 25 %. Although the test source is highly polarized, the DOP at the output of the OA is reduced by amplified spontaneous emission (ASE). Annex A analyses the impact of ASE on the DOP. In order to assure an accurate measurement, the DOP is measured as part of the measurement procedure. The method described herein has been shown to be immune to polarization-dependent gain (PDG) and polarization dependent loss (PDL) up to approximately 1 dB. Although the Jones matrix eigenanalysis (JME) test method is in principle also applicable to unpumped (that is, unpowered) OAs, the JME technique in this standard applies to pumped (that is, powered) OAs only.

ICS

33.180.30 Optikai erősítők

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2009-01-01

Forrás

idt EN 61290-11-1:2008; idt IEC 61290-11-1:2008

Előd

MSZ EN 61290-11-1:2003

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 451392) ,

oldalszáma

14 oldal; G kategória

ára

Nettó: 8000 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 10080 Ft
PDF (letöltés) formátum esetén (27% Áfával): 10160 Ft