Hivatkozási szám

MSZ EN ISO 6145-6:2008

Dokumentumazonosító

146399

Cím

Gázelemzés. Kalibráló gázkeverékek előállítása dinamikus térfogati módszerekkel. 6. rész: Kritikus fúvókák (ISO 6145-6:2003)

Angol cím

Gas analysis. Preparation of calibration gas mixtures using dynamic volumetric methods. Part 6: Critical orifices (ISO 6145-6:2003)

Alkalmazási terület

ISO 6145-6:2003 specifies a method for the continuous production of calibration gas mixtures, containing two or more components, from pure gases or other gas mixtures by use of critical orifice systems. By selection of appropriate combinations of orifices and with the use of pure gases, the volume fraction of the calibration component in the calibration gas mixture can be varied by a factor of 104. Additionally, it can be changed by a factor of 102 by changing the initial pressures in the orifice systems. The uncertainty of the method depends mainly upon the flow calibration method and the variations in temperature and outlet pressure. The relative expanded uncertainty in the volume fraction obtainable for a binary mixture (at a coverage factor of 2) is 3 %. If pre-mixed gases are used instead of pure gases, much lower volume fractions can be obtained. The mass flow rates or volume flow rates, from which the mass or volume fractions are determined, can be calculated and can be independently measured by a suitable method given in ISO 6145-1. The merits of the method are that multi-component mixtures can be prepared as readily as binary mixtures if the appropriate number of orifices is utilized, and that a large quantity of calibration gas mixture can be prepared on a continuous basis. The range of flow rates can be from several millilitres per minute to approximately 10 l/min. Although particularly applicable to preparation of gas mixtures at barometric pressure, the method also provides a means of preparation of calibration gas mixtures at pressures above barometric pressure.

ICS

71.040.40 Vegyelemzés

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2008-11-01

A visszavonás napja

2018-03-01

Forrás

idt EN ISO 6145-6:2008; idt ISO 6145-6:2003

Előd

Utód

MSZ EN ISO 6145-6:2018

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 573034) ,

oldalszáma

16 oldal; H kategória

ára

Nettó: 8640 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 10886 Ft
PDF (letöltés) formátum esetén (27% Áfával): 10973 Ft