Hivatkozási szám

MSZ EN 60664-5:2008

Dokumentumazonosító

145240

Cím

Kisfeszültségű rendszerek villamos szerkezeteinek szigeteléskoordinációja. 5. rész: A legfeljebb 2 mm méretű légközök és kúszóáramutak meghatározásának átfogó jellegű módszere (IEC 60664-5:2007)

Angol cím

Insulation coordination for equipment within low-voltage systems. Part 5: A comprehensive me¬thod for determining clearances and creepage distances equal to or less than 2 mm (IEC 60664-5: 2007)

Alkalmazási terület

This part of IEC 60664 specifies the dimensioning of clearances and creepage distances for spacings equal to or less than 2 mm for printed wiring board and equivalent constructions, where the clearance and the creepage distance are identical and are along the surface of solid insulation, such as the paths described in 6.2 of Part 12 (Examples 1, 5 and 11). The dimensioning in this standard is more precise than that provided by Part 1. However, if the precision provided by this standard is not required, Part 1 may be applied instead. This standard can only be used in its entirety. It is not permitted to select one or more clauses from this standard and to use them in place of the corresponding clauses of Part 1. In addition, this part of IEC 60664 can only be used together with Part 1. When this Part 5 is applied to the dimensioning of clearances and creepage distances equal to or less than 2 mm, all clauses are used in place of the corresponding clauses given in Part 1. For clearances and creepage distances larger than 2 mm, and for solid insulation in general, Part 1 applies. NOTE 1 The limitation to distances equal to or less than 2 mm applies to basic or supplementary insulation. The total distance of a reinforced or double insulation may be larger than 2 mm. This standard is based on the following criteria for dimensioning: – minimum clearances independent of the micro-environment (see Table 2); – minimum creepage distances for pollution degrees 1, 2 and 3 to avoid failure due to tracking (see Table 4); – minimum creepage distances to avoid flashover across the insulating surface (see Table 5). NOTE 2 For minimum creepage distances to maintain adequate insulation resistance, see Table A.2. NOTE 3 This standard is not applicable to micro-environmental conditions worse than pollution degree 3 or humidity level 3. A test method is specified for allocating unclassified insulating material to the relevant water adsorption group.

ICS

29.080.30 Szigetelőrendszerek

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2008-05-01

A visszavonás napja

2022-04-01

Forrás

idt IEC 60664-5:2007; idt EN 60664-5:2007

Előd

MSZ EN 60664-5:2004

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

2006/95/EK; (LVD06)

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 626927) ,

oldalszáma

45 oldal; S kategória

ára

Nettó: 15070 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 18988 Ft
PDF (letöltés) formátum esetén (27% Áfával): 19139 Ft