Hivatkozási szám

MSZ EN 1845:2008

Dokumentumazonosító

145010

Cím

Cipőgyártó gépek. Cipőipari fröccsöntő gépek. Biztonsági követelmények

Angol cím

Footwear manufacturing machines. Footwear moulding machines. Safety requirements

Alkalmazási terület

This European Standard applies to footwear moulding machines which are intended for use in the shoe industry for the production of footwear and footwear components. These machines are: - direct-on sole moulding machines (see Figures 1, 2 and 3); - unit sole and footwear component moulding machines (see Figures 4 to 10); - full shoe and boot moulding machines (see Figure 11). This European Standard applies also to the mentioned machines when used for other products than footwear and footwear components, as far as these products require no other changes than a different mould. 1.2 This European Standard specifies safety requirements for construction, transport, installation, adjustment, setting, teaching or process change-over, operation, cleaning, maintenance, decommissioning, dismantling and, as far as safety is concerned, disposal for machines mentioned in l.1. It deals with all significant hazards, hazardous situations and events relevant to footwear moulding machines, when they are used as intended and under conditions of misuse which are reasonably foreseeable by the manufacturer (see Clause 4). 1.3 The following machines are excluded from the scope of this European Standard unless used for direct-on sole moulding or reaction moulding: - moulding machines with static injection units and static mould stations (clamping units); - moulding machines with static metering and mixing units and mobile stations with linear configuration (mould carriers). 1.4 The European Standard does not deal with hazards created by the mixing and metering unit. NOTE For metering and mixing units, see EN 1612-1. The use of machines within the scope of this European Standard in industries other than those specified in 1.1 may give rise to hazards not considered during its preparation. NOTE For this application see also EN 201 and prEN 1612-2. 1.5 This European Standard also applies to the following additional equipment for material handling and operation which are an integ

ICS

61.060 Lábbelik

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2008-03-01

Forrás

idt EN 1845:2007

Előd

MSZ EN 1845:2001

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

2006/42/EK AZ EURÓPAI PARLAMENT ÉS A TANÁCS 2006/42/EK IRÁNYELVE (2006. május 17.) a gépekről és a 95/16/EK irányelv módosításáról (átdolgozás) (EGT vonatkozású szöveg) (MAC06)

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 909566) ,

oldalszáma

83 oldal; X kategória

ára

Nettó: 21330 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 26876 Ft
PDF (letöltés) formátum esetén (27% Áfával): 27089 Ft