Hivatkozási szám

MSZ EN 10083-1:2006

Dokumentumazonosító

141881

Cím

Nemesíthető acélok. 1. rész: Általános műszaki szállítási feltételek

Angol cím

Steels for quenching and tempering. Part 1: General technical delivery conditions

Alkalmazási terület

This part of EN 10083 specifies the general technical delivery requirements for semi-finished products, hot formed, e.g. blooms, billets, slabs (see NOTES 2 and 3), bars (see NOTE 2), rod, wide flats, hot-rolled strip and sheet/plate, forgings (see NOTE 2) manufactured from the direct hardening non alloy steels for quenching and tempering (see EN 10083-2), the direct hardening alloy steels for quenching and tempering (see EN 10083-3), the non alloy flame and induction hardening steels (see EN 10083-2) and the alloy flame and induction hardening steels (see EN 10083-3), and supplied in one of the heat treatment conditions given for the different types of products in the relevant tables of EN 10083-2 and EN 10083-3 and in one of the surface conditions given in the relevant tables of EN 10083-2 and EN 10083-3. The steels are generally intended for the manufacture of quenched and tempered, flame or induction hardened machine parts, but can also be used in the normalized condition (see EN 10083-2). Where applicable, the requirements for mechanical properties given in EN 10083-2 and EN 10083-3 are restricted to the relevant tables in these documents. NOTE 1 European Standards on similar grades are listed in Annex C. NOTE 2 Hammer forged semi-finished products (blooms, billets, slabs etc.), seamless rolled rings and hammer forged bars are in the following covered under semi-finished products or bars and not under the term "forgings". NOTE 3 Special agreements should be made when ordering un-worked continuously cast semi-finished products. NOTE 4 In accordance with EN 10020, the steels covered by EN 10083-2:2006 are quality and special steels, the steels covered by EN 10083-3:2006 are special steels. The differences between quality and special steels are characterized by the following requirements, which are valid for special steels only: the minimum impact values in the quenched and tempered condition (for non alloy special steels in the case of

ICS

77.140.10 Hőkezelhető acélok

Műszaki Bizottság

A szabvány nyelve

angol

Az érvényesség kezdete

2006-12-01

A visszavonás napja

2018-11-01

Forrás

idt EN 10083-1:2006

Előd

MSZ EN 10083-1:1991+A1:2000

Utód

MSZ EN ISO 683-1:2018, MSZ EN ISO 683-2:2018

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 424956) ,

oldalszáma

26 oldal; M kategória

ára

Nettó: 11290 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 14225 Ft
PDF (letöltés) formátum esetén (27% Áfával): 14338 Ft