Hivatkozási szám

MSZ EN 12797:2005

Dokumentumazonosító

136404

Cím

Keményforrasztás. A keményforrasztott kötések roncsolásos vizsgálatai

Angol cím

Brazing. Destructive test of brazed joints

Alkalmazási terület

This European Standard describes destructive test procedures and test piece types necessary to perform the tests on brazed joints. Brazed joints are used in a wide variety of assemblies and the design requirements placed upon these joints will also vary widely; there will usually be some level of strength required but this may not be explicitly stated and is frequently of minor importance compared to some other criterion, e.g. hermeticity. It follows that a test which measures strength may be totally irrelevant in assessing a joint for a particular application where strength is a minor consideration. This situation is made more complicated because brazed joints are almost invariably designed to be loaded in shear and the dimensions of the joint affect the shear strength to a much greater extent than they do the tensile strength. The tests described in this standard have been used successfully to give information on specific properties and where such information is needed, it is recommended that one of them be specified. It is vital to recognise that for many fabrications none of these tests will be suitable and specific tests will have to be devised, which do yield the requisite information (which may be qualitative rather then quantitative). The destructive test methods described are as follows: a) shear tests (see clause 4); b) tensile tests (see clause 5); c) metallographic examination (see clause 6); d) hardness tests (see clause 7); e) peel test (see clause 8); f) bend tests (see clause 9). Details of burst tests are not included as these are not commonly used on brazed joints. The type of test piece described for each test can be quoted or incorporated in engineering applications standards that deal with brazed assemblies. The results of the tests are used: 1) to determine basic data regarding filler metal performance; 2) to arrive at optimum brazing designs (including gaps) and brazing procedures...(Truncated)

ICS

25.160.50 Keményforrasztás és lágyforrasztás

Műszaki Bizottság

A szabvány nyelve

magyar

Az érvényesség kezdete

2005-03-01

Forrás

idt EN 12797:2000; idt EN 12797:2000/A1:2003

Előd

MSZ EN 12797:2000, MSZ EN 12797:2000/A1:2004

Utód

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 580284) ,

oldalszáma

29 oldal; N kategória

ára

Nettó: 11980 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 15095 Ft
PDF (letöltés) formátum esetén (27% Áfával): 15215 Ft