Hivatkozási szám

MSZ EN 1028-1:2003

Dokumentumazonosító

125167

Cím

Tűzoltó szivattyúk. Tűzoltó centrifugálszivattyúk légtelenítővel. 1. rész: Osztályozás. Általános és biztonsági követelmények

Angol cím

Fire-fighting pumps. Fire-fighting centrifugal pumps with primer. Part 1: Classification. General and safety requirements

Alkalmazási terület

This standard applies for centrifugal pumps with priming devices for fire-fighting use supplied separately without driver and couplings. Fire-fighting centrifugal pumps with primer are defined as terminated by their inlet and outlet connec-tions as well as by their shaft ends. This standard applies for fire-fighting centrifugal pumps with priming devices for use under ambient temperatu-res between -15 °C and 40 °C. NOTE For special conditions, -30 °C; see 6.12. This standard does not apply to fire-fighting centrifugal pumps with primer of which the only power source is directly applied manual effort. This standard specifies the classification and general requirements for fire-fighting centrifugal pumps with priming devices with a nominal delivery rate of up to 6000 l/min. This standard deals with significant hazards listed in clause 4, hazardous situations and events during the commis-sio-ning, operation and maintenance of fire-fighting centrifugal pumps with priming devices, used as intended and under the conditions foreseen by the manufacturer or the manufacturer's authorized representati-ve. In addition, fire-fighting centrifugal pumps with priming devices shall conform as appropriate to EN 292 for hazards not covered by this standard. This standard does not deal with the detailed verification of general and safety requirements and/or protective measures. These are covered in prEN 1028-2 "Verification of general and safety requirements". This standard does not deal with the technical safety requirements for the design or manufacture of drivers or of auxiliary equipment. It does not cover risks directly arising from means provided for the portability, trans-portability, and mobility of pump units during or between periods of operation, or requirements for transmission shafts linking self-propelled machinery to a pump. In addition, this standard does not cover:

ICS

13.220.10 Tűzoltás

A szabvány nyelve

magyar

Az érvényesség kezdete

2003-08-01

A visszavonás napja

2009-04-01

Forrás

idt EN 1028-1:2002

Előd

Utód

MSZ EN 1028-1:2002+A1:2009

Módosítás

Kiegészítő információk

SZK-közlemények

Kapcsolódó európai jogszabály

(MAC98)

A szabvány

kapható formátuma

Papír ,
PDF (letöltés) (a fájl mérete: 299866) ,

oldalszáma

30 oldal; P kategória

ára

Nettó: 12520 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 15775 Ft
PDF (letöltés) formátum esetén (27% Áfával): 15900 Ft