MSZ EN ISO 1133-1:2012

Műanyagok. A hőre lágyuló műanyagok tömegre (MFR) és térfogatra (MVR) vonatkoztatott folyási mutatószámának meghatározása. 1. rész: Szabványos módszer (ISO 1133-1:2011)

Plastics. Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics. Part 1: Standard method (ISO 1133-1:2011)


This part of ISO 1133 specifies two procedures for the determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastic materials under specified conditions of temperature and load. Procedure A is a mass-measurement method. Procedure B is a displacement-measurement method. Normally, the test conditions for measurement of melt flow rate are specified in the material standard with a reference to this part of ISO 1133. The test conditions normally used for thermoplastics are listed in Annex A. The MVR is particularly useful when comparing materials of different filler content and when comparing filled with unfilled thermoplastics. The MFR can be determined from MVR measurements, or vice versa, provided the melt density at the test temperature is known. This part of ISO 1133 is also possibly applicable to thermoplastics for which the rheological behaviour is affected during the measurement by phenomena such as hydrolysis (chain scission), condensation and crosslinking, but only if the effect is limited in extent and only if the repeatability and reproducibility are within an acceptable range. For materials which show significantly affected rheological behaviour during testing, this part of ISO 1133 is not appropriate. In such cases, ISO 1133-2 applies. NOTE The rates of shear in these methods are much smaller than those used under normal conditions of processing, and therefore it is possible that data obtained by these methods for various thermoplastics will not always correlate with their behaviour during processing. Both methods are used primarily in quality control.

Általános információk

Érvényes
angol
: 2012-06-01

83.080.20 - Hőre lágyuló anyagok

MSZT/MB 711  Műanyagok

: idt ISO 1133-1:2011; idt EN ISO 1133-1:2011


Vásárlás

: 9 060,0 Ft
(papír , PDF-fájl-letöltés)



Szabvány életútja

Előzmények
Megtekintett szabvány
MSZ EN ISO 1133-1:2012

2012-06-01

Utódok

Jelenleg nincsenek utódok