Szabványkereső

Hivatkozási szám, azonosító jelzet, vagy a szabványcímben előforduló kulcsszó szerinti keresés:


ICS (a szabványok nemzetközi osztályozási rendszere) szerinti keresés

Nettó ár: 8640 Ft
Kosárba tesz
Alapadatok
Hivatkozási szám
MSZ EN 61558-2-13:2010
Dokumentumazonosító
149389
Cím
Legfeljebb 1100 V tápfeszültségű transzformátorok, indukciós tekercsek, tápegységek és hasonló termékek biztonsága. 2-13. rész: Takaréktranszformátorok és azokat tartalmazó tápegységek egyedi követelményei és vizsgálatai (IEC 61558-2-13:2009)
Angol cím
Safety of transformers, reactors, power supply units and similar products for supply voltages up to 1 100 V. Part 2-13: Particular requirements and tests for auto transformers and power supply units incorporating auto transformers (IEC 61558-2-13:2009)
Alkalmazási terület
Replacement: This part of IEC 61558 deals with the safety of auto transformers for general applications and power supply units incorporating auto transformers for general applications. Transformers incorporating electronic circuits are also covered by this standard. NOTE 1 Safety includes electrical, thermal and mechanical aspects. Unless otherwise specified, from here onward, the term transformer covers auto transformers for general applications and power supply units incorporating auto transformers for general applications. NOTE 2 : For power supply units (linear) this part is applicable. For switch mode power supply units, IEC 61558-2-16 is applicable together with this part. This part is applicable to stationary or portable, single-phase or polyphase, air-cooled (natural or forced) independent or associated dry- type transformers. The windings may be encapsulated or non-encapsulated. The rated supply voltage does not exceed 1 100 V a.c., and the rated supply frequency and the internal operating frequencies do not exceed 500 Hz. The core power does not exceed: – 2 kVA for single-phase transformers; – 10 kVA for polyphase transformers. The rated output does not exceed: – 40 kVA for single-phase transformers; – 200 kVA for polyphase transformers. This part is applicable to transformers without limitation of the core power and the rated output both being subject to an agreement between the purchaser and the manufacturer. Where applicable, the no-load output voltage or the rated output voltage does not exceed 1 000 V a.c. or 1 415 V ripple-free d.c., and for independent transformers, the no-load output voltage and the rated output voltage exceeds 50 V a.c., or 120 V ripple-free d.c. This part is not applicable to external circuits and their components intended to be connected to the input terminals and output terminals of the transformers. Transformers covered by this part are used only in applications where no insulation between circuits is required by the installation rules or by the end product standard. NOTE 3 Attention is drawn to the following: – for transformers intended to be used in vehicles, on board ships, and aircraft, additional requirements (from other applicable standards, national rules, etc.) may be necessary; – measures to protect the enclosure and the components inside the enclosure against external influences such as fungus, vermin, termites, solar-radiation, and icing should also be considered; – the different conditions for transportation, storage, and operation of the transformers should also be considered; – additional requirements in accordance with other appropriate standards and national rules may be applicable to transformers intended for use in special environments. NOTE 4 Future technological development of transformers may necessitate a need to increase the upper limit of the frequencies, until then this part may be used as a guidance document.
ICS
29.180 Transzformátorok. Fojtótekercsek
A szabvány nyelve
angol
Az érvényesség kezdete
2010-04-01
További adatok
Forrás
idt IEC 61558-2-13:2009; idt EN 61558-2-13:2009
Utód
Módosítás
Kiegészítő információk
SZK-közlemények
Kapcsolódó európai jogszabály
2014/35/EU (LVD14); 2006/95/EK; (LVD06)
Kereskedelmi adatok
A szabvány
kapható formátuma
Papír ,
PDF (letöltés) (a fájl mérete: 468396) ,
oldalszáma
16 oldal; H kategória
ára
Nettó: 8640 Ft
Bruttó:
Papír formátum esetén (5% Áfával): 10886 Ft
PDF (letöltés) formátum esetén (27% Áfával): 10973 Ft
Szabvány életútja
Megtekintett szabvány

MSZ EN 61558-2-13:2010

2010-04-01

Utódok

Jelenleg nincsenek utódok